1/spl phi/ 3W grid-connection PV power inverter with partial active power filter

This paper presents a single-phase three-wire (1/spl phi/ 3W) grid-connection photovoltaic (PV) power inverter with a of partial active power filter (PAPF) feature, which can not only deal with PV power but filter current harmonics and improve power factor. Once the processed power exceeds the switch ratings, the inverter can reduce its output reactive power and harmonic power, while still supplying the maximum real power generated by the PV arrays. In the derivation of control laws, a limit circle is defined to confine the output power of the inverter. To determine the power that the inverter can process, the instantaneous reactive power of a 1/spl phi/ 3W system is defined and used to calculate reactive power, which can avoid complex detections of phase angle and magnitude of the fundamental component of a nonlinear load current. Simulation results and experimental measurements have verified the proposed algorithm and the feasibility of the inverter.     

如何为《飞机工程》撰写符合规范又有创新的论文

介绍了科技论文规范表达对收集、储存、处理、加工、检索、利用、交流和传播的作用，结合《飞机工程》投稿的实际，指出了作者在文字、标点、符号、图表、公式、量和单位表达中容易忽视和写错的一些技术细节，给出了科技论文规范表达的撰写格式，以及为《飞机工程》投稿时应注意的事项。     

Aperture error mitigation via local-state estimation for frequency-based emitter location

This paper considers the problem of locating a stationary coherent emitter via a single moving platform making frequency measurements in the presence of aperture state uncertainty. It is shown that the estimated emitter location is most sensitive to the receiving aperture velocity uncertainty. The required aperture velocity accuracy is determined through a noninfinitesimal perturbation analysis. A solution to location accuracy enhancement with a minimal hardware addition is attempted. It is shown that this can be achieved by mounting a high-resolution tri-axis microelectromechanical systems (MEMS) accelerometer at the aperture to measure its velocity, which can deviate significantly from that estimated by the on-board navigation system. The Doppler shifts of the GPS signal carrier frequency, whenever it can be acquired through the aperture, are also considered as a way to aid the aperture velocity measurement. A decentralized, federated processing method for the aperture velocity estimate referenced at the aperture, integrating all measurement data, is presented. An upper bound for the error of aperture velocity estimate is derived. The potential for significant accuracy enhancement for emitter location is demonstrated.     

毕棚沟 一路走过

梦是对无限、永远的可能的相信，而现实并不……黑、白棋总是在棋盘上腾转挪移，而黑、白并不……[编者按]     

扩频码协议在集中式扩频无线分组网中的应用

从集中式扩频无线分组网的角度出发，着重讨论了正向链路和反向链路上的扩频码协议的选择问题，并且提出了一种扩频码协议的具体实现方案。     

基于PCI总线的石英晶体元件电参数测试仪

首先介绍PCI总线控制专用芯片S5920的组成,Mailboxs、FIFO、Pass-Thru的基本概念、性能和使用方法。其次介绍测量石英晶体元件参数的阻抗计法和π网络法。对基于PCI总线控制器S5920为核心的π网络法石英晶体元件电参数测试仪的设计和实现作了说明。该方法测量的频率可达2005MHz。利用GPs高精度的授时信号作为频率校准信号校准信号源的精度。     

QPSK信号相干检测的错误概率计算公式辨析

在各种文献中 ,QPSK信号相干检测错误概率的计算公式和相应的曲线往往互不相同 ,使工程设计者常感困惑。文中对这些差异及其本质作出详细分析 ,以求正本清源     

论带通信道的信道容量的不确定性

依据山农的经典论证方法 ,证明山农信道容量定理仅适用于低通信道 ,不适用于带通信道。对于带通信道 ,信道容量将随信道通带的中心频率而改变。所以带通信道的信道容量具有不确定性。     

模拟磁带重放信号数字化过程中的频偏校正技术及应用

模拟磁带重放信号中存在的频率偏移会对信号的处理分析产生不利影响。利用模拟磁记录器的多个磁道同时记录的能力,将实际信号和特定的参考信号同时进行记录,磁带信号重放和数字化过程中,利用这个参考信号来控制A/D采集时钟的速度,从而可在很大程度上减少磁带重放系统带来的频率偏移。实验结果表明,该技术方法能有效地解决模拟磁带重放信号中存在的频偏问题。     

一个简单有效的磁记录纠错系统

介绍一种简单有效的纠错编码方法 ,用于资源卫星高密度数字磁记录器 ,使误码率由 10 -6降低到 10 -11,同时介绍它的基本工作原理、实现方案及试验结果。